How to Clean Spackle | HomeSteady

Spackle is a plastic-like paste used to fill cracks or holes in plaster or drywall. Ceilings are also often spackled to provide texture. Spackle is messy, whether you're applying a small patch or covering a large surface. It gets on tools and on the floor.

Spackling is messy.

Because spackle dries hard quickly, it's important to clean it up right away. Cleaning up dried spackle requires a bit more work.

Things You Will Need

Sponge
Plastic putty knife
Paper towels
Window cleaner or vinegar
Wood oil
Vacuum
Spot remover
Plastic-bristle scrub brush

Concrete and Tile Floors

Wipe up spackle that is still wet with a damp sponge.
Wipe the area dry with a dry, clean towel to eliminate any spackle residue. If, after drying, a white film remains on the surface of the floor, wipe it up again with a fully rinsed-out sponge.
Scrape up dried bits of spackle stuck to the floor using a plastic putty knife. Avoid using a metal putty knife -- it can scratch the floor.
Cover any dried bits remaining with damp paper towels. Leave the paper towels for several minutes and allow the moisture to soften the spackle.
Scrape the softened spackle with the putty knife and wipe up any residue with the sponge.

Wood Floors

Wipe up any spackle that is still wet with a dry towel. Do not use water on wood floors.
Clean up any remaining residue with window cleaner or vinegar.
Drop wood oil onto dried, stuck-on spackle and allow it to saturate and soften the spackle. Oil will not impregnate and compromise wood floor boards like water.
Scrape the softened spackle with a plastic putty knife and clean the residue with window cleaner or vinegar.

Carpet

Allow spackle dropped on the carpet to dry since dry spackle is easier to remove from carpet than wet spackle.
Vacuum the carpet to crumble and suck up as much spackle as possible.
Spray carpet spot remover on remaining plaster.
Blot up the plaster, using paper towels.

Tools

Run the blades of spackling tools under water immediately after using to rinse away the plaster while wet. Use fingers to rub away as much spackle as possible.
Scrub the tools with water and a plastic-bristle scrub brush to remove wet spackle from crevices.
Scrape the tools with a plastic putty knife and continue to scrub them with water and a scrub brush to remove dried spackle.

The Drip Cap

Spackle is a plastic-like paste used to fill cracks or holes in plaster or drywall.
Wipe up any spackle that is still wet with a dry towel.
Do not use water on wood floors.
Drop wood oil onto dried, stuck-on spackle and allow it to saturate and soften the spackle.
Scrape the softened spackle with a plastic putty knife and clean the residue with window cleaner or vinegar.
Run the blades of spackling tools under water immediately after using to rinse away the plaster while wet.